Lincoln Navigator: Wipers and Washers / Windshield Washer Jets. Removal and Installation
Removal
NOTE:
Removal steps in this procedure may contain installation details.
-
Remove the cowl panel grille.
Refer to: Cowl Panel Grille (501-02 Front End Body Panels, Removal and Installation).
-
Disconnect the windshield washer fluid house coupler.
-
NOTE:
LH (left-hand) side shown, RH (right-hand) side similar.
Depress the locking tabs and remove the windshield washer jet.
Installation
-
To install, reverse the removal procedure.
Special Tool(s) /
General Equipment
Two Leg Puller
Removal
NOTE:
Removal steps in this procedure may contain installation details...
Special Tool(s) /
General Equipment
Fluid Suction Gun
Materials
Name
Specification
Motorcraft® Premium Windshield Wash Concentrate with BitterantZC-32-B2
WSS-M14P19-A
Removal
Open the windshield washer reservoir lid...
Other information:
Removal
If a new IPMA is being installed, using a diagnostic scan tool, begin
the PMI process for the IPMA following the on-screen instructions.
Disconnect the trailer tow lighting module electrical connectors.
Remove the bolts and trailer tow lighting module...
Check
Measure the piston diameter 90 degrees from the
piston pin and piston diameter (DN) height down from the top of the
piston at the point indicated.
Refer to specifications for the piston diameter (DN) height...