Lincoln Navigator: Auxiliary Brake System / Trailer Brake Control Switch. Removal and Installation
Removal
-
Remove the instrument panel center finish panel.
Refer to: Instrument Panel Center Finish Panel (501-12 Instrument Panel and Console, Removal and Installation).
- Pust the tabs and remove the trailer brake control switch.
 |
Installation
- To install, reverse the removal procedure.
Other information:
Lincoln Navigator 2018-2026 Workshop Manual: Electronic Engine Controls - Component Location. Description and Operation
Electronic Engine Controls- Front Item Description 1 Turbocharger Boost Pressure (TCBP) Charge Air Cooler (CAC) Temperature sensor 2 Right hand VCT oil control solenoids 3 MAPT sensor 4 Crankcase Pressure Sensor 5 Left hand VCT oil control solenoids 6 IAT sensor Electronic Engine Controls- Front ..
Lincoln Navigator 2018-2026 Workshop Manual: Blind Spot Information System. Diagnosis and Testing
Diagnostic Trouble Code (DTC) Chart Diagnostics in this manual assume a certain skill level and knowledge of Ford-specific diagnostic practices. REFER to: Diagnostic Methods (100-00 General Information, Description and Operation). Module DTC Description Action DDM B118C:11 Left Blind Spot Warning Indicator: Circuit Short To Ground GO to Pinpoint Test D DDM ..
Categories
- Manuals Home
- 4th Gen Lincoln Navigator Service Manual (2018 - 2026)
- Windshield Washer Pump. Removal and Installation
- All Terrain Control Module (ATCM). Removal and Installation
- Telematics Control Unit (TCU) Module. Removal and Installation
- Head Up Display (HUD) Module Calibration. General Procedures
- Transmission Fluid Drain and Refill. General Procedures
Diagnostic Methods. Description and Operation
This document provides critical diagnostic knowledge required for successful repair outcomes. It identifies technical competencies expected by users of this manual.
Ford Diagnostic Assumptions
Ford diagnostics assume the vehicle concern described by the test title is currently present. Exceptions to this rule are noted in each test. Do not replace modules or other components as directed by a diagnostic if the concern is not present at the time of testing.
