Lincoln Navigator: Steering Wheel and Column Electrical Components / Steering Column Control Switch. Removal and Installation
Removal
NOTE: Removal steps in this procedure may contain installation details.
-
Remove the steering column shrouds.
Refer to: Steering Column Shrouds (501-05 Interior Trim and Ornamentation, Removal and Installation).
-
Remove the steering column control switch retainer.
 |
-
Remove the steering column control switch.
-
Disconnect the electrical connector.
-
Release the clip and remove the steering column control switch.
-
Disconnect the electrical connector.
 |
Installation
-
To install, reverse the removal procedure.
Steering Column Control Module (SCCM). Removal and Installation
Removal
NOTE:
Removal steps in this procedure may contain installation details.
NOTE:
This step is only necessary when installing a new component...
Steering Column Multifunction Switch LH. Removal and Installation
Removal
NOTE:
Removal steps in this procedure may contain installation details.
Remove the steering column shrouds.
Refer to: Steering Column Shrouds (501-05 Interior Trim and Ornamentation, Removal and Installation)...
Other information:
Lincoln Navigator 2018-2026 Workshop Manual: Liquefied Petroleum Gas (LPG) and Compressed Natural Gas (CNG) Fuel Systems Health and Safety Precautions. Description and Operation
WARNING: Service of Compressed Natural Gas (CNG) or Liquefied Petroleum Gas (LPG) vehicle systems is restricted to qualified personnel and authorized workshops. The required qualifications vary by region. Always observe local laws and legislative directives regarding CNG or LPG vehicle service...
Lincoln Navigator 2018-2026 Workshop Manual: Shock Absorber and Spring Assembly. Disassembly and Assembly
Special Tool(s) / General Equipment Spring Compressor Vise DISASSEMBLY NOTICE: Suspension fasteners are critical parts that affect the performance of vital components and systems. Failure of these fasteners may result in major service expense...
Categories
- Manuals Home
- 4th Gen Lincoln Navigator Service Manual (2018 - 2026)
- Vehicle Dynamics Control Module (VDM). Removal and Installation
- Rear View Mirrors - System Operation and Component Description. Description and Operation
- SYNC Module [APIM]. Removal and Installation
- All Terrain Control Module (ATCM). Removal and Installation
- Identification Codes. Description and Operation
Axle Tube Bearing. Removal and Installation
Special Tool(s) / General Equipment
205-123
(T78P-1177-A)
Installer, Axle Shaft Oil Seal
308-047
(T77F-1102-A)
Remover, Bearing Cup Slide Hammer
