Lincoln Navigator: Handles, Locks, Latches and Entry Systems / Staged Unlock Programming. General Procedures
Programming
-
Refer to: Health and Safety Precautions (100-00 General Information, Description and Operation).
WARNING:
Before beginning any service procedure in this
manual, refer to health and safety warnings in section 100-00 General
Information. Failure to follow this instruction may result in serious
personal injury.
-
With the ignition in OFF, press the lock and unlock buttons on the RKE transmitter simultaneously for 4 seconds.
-
The turn signals flash twice to indicate the mode change.
-
Repeat Step 2 to enable/disable the staged unlocking feature.
Liftgate Latch Manual Release. General Procedures
Special Tool(s) /
General Equipment
Flat-Bladed Screwdriver
Interior Trim Remover
Activation
Open the liftgate window glass...
Approach Detection Antenna. Removal and Installation
Special Tool(s) /
General Equipment
Rivet Gun
Removal
NOTE:
Removal steps in this procedure may contain installation details.
Remove the front bumper cover...
Other information:
Lincoln Navigator 2018-2026 Workshop Manual: Thermostatic Expansion Valve. Removal and Installation
Removal NOTICE: During the removal or installation of components, cap, tape or otherwise appropriately protect all openings and tubes/fittings to prevent the ingress of dirt or other contamination. Remove caps, tape and other protective materials prior to installation...
Lincoln Navigator 2018-2026 Workshop Manual: Rear Audio Control Module (RACM). Removal and Installation
Special Tool(s) / General Equipment Interior Trim Remover Removal NOTE: If installing a new module, it is necessary to upload the module configuration information to the scan tool prior to removing the module. This information must be downloaded into the new module after installation...
Categories
- Manuals Home
- 4th Gen Lincoln Navigator Service Manual (2018 - 2026)
- Identification Codes. Description and Operation
- Transmission Fluid Drain and Refill. General Procedures
- Rear View Mirrors - System Operation and Component Description. Description and Operation
- Body Control Module (BCM). Removal and Installation
- SYNC Module [APIM]. Removal and Installation
Rear Drive Axle and Differential. Diagnosis and Testing
Symptom Chart(s)
Diagnostics in this manual assume a certain skill level and knowledge of Ford-specific diagnostic practices.
REFER to: Diagnostic Methods (100-00 General Information, Description and Operation).
Symptom Chart - Differential
Symptom Chart - Differential
Condition Actions Axle overheating GO to Pinpoint Test A Broken gear teeth on the ring gear or pinion GO to Pi
