Lincoln Navigator: Body System - General Information / Specifications
Materials
| Name | Specification |
|---|---|
| Seam Sealer TA-2-B, 3M™ 08308, LORD Fusor® 803DTM |
- |
| Motorcraft® High Performance Engine RTV Silicone TA-357 |
WSE-M4G323-A6 |
| Motorcraft® Silicone Spray Lubricant XL-6 |
ESR-M13P4-A |
| Permatex® Trim and Weatherstrip Adhesive 81850 |
- |
Body - Overview. Description and Operation
Insulation
Insulation
is used as a sound-deadener to reduce exterior road and powertrain
noises from the interior of the vehicle. Mastic insulators are also used
as insulation...
Other information:
Lincoln Navigator 2018-2026 Workshop Manual: Rear Drive Axle and Differential. Description and Operation
The 9.75-inch ring gear rear conventional differential has 3.31 and 3.73 gear ratio versions. The 9.75-inch ring gear rear differential with eLSD has 3.73 gear ratio. Rear Drive Axle and Differential The rear axle assembly consists of the following: Integral-type housing hypoid gear design (center of the pinion set below the centerline of the ring gear) Hypoid differentia..
Lincoln Navigator 2018-2026 Workshop Manual: Compression and Cylinder Leakage Test. General Procedures
Make sure the oil in the crankcase is of the correct viscosity and at the correct level and that the battery is correctly charged. Operate the vehicle until the engine is at normal operating temperature. Turn the ignition switch to the OFF position. Remove the spark plugs. For additional information, refer to: Spark Plugs (303-07 Engine Ignition - 3.5L EcoBoost (27..
Categories
- Manuals Home
- 4th Gen Lincoln Navigator Service Manual (2018 - 2026)
- Rear Bumper. Removal and Installation
- Body Control Module (BCM). Removal and Installation
- Transmission Fluid Level Check. General Procedures
- Neutral Flat Tow Activation and Deactivation. General Procedures
- Power Running Board (PRB). Diagnosis and Testing
Rear Camber Adjustment. General Procedures
Special Tool(s) / General Equipment
Wheel Alignment SystemActivation
NOTICE: Suspension fasteners are critical parts that affect the performance of vital components and systems. Failure of these fasteners may result in major service expense. Use the same or equivalent parts if replacement is necessary. Do not use a replacement part of lesser quality or substitute design. Tighten fasteners as specified.
Using alignment equipment and the manufacturer's instructions, measure the rear camber.Use the General Equipment: Wheel Alignment System
