Lincoln Navigator: Fuel System - General Information - 3.5L EcoBoost (272kW/370PS) / Specifications
General Specifications
| Item | Specification |
|---|---|
| Fuel Pressure | |
| Engine running. | 44 –73 psi ( 300 –500 kPa) |
| Fuel Tank Capacity | |
| Fuel Tank Capacity - LWB. | 28 gal ( 105.2 L) |
| Fuel Tank Capacity - SWB. | 23 gal ( 87.1 L) |
Fuel System - Overview. Description and Operation
Overview
The fuel system consists of:
a Closed Loop Pressure Control (CLPC) system.
fuel and vapor lines in an integrated bundle assembly...
Other information:
Lincoln Navigator 2018-2026 Workshop Manual: Front Active Park Assist Sensors. Removal and Installation
Removal NOTE: Removal steps in this procedure may contain installation details. NOTE: LH side shown, RH side similar. Remove the front wheel and tire assembly. Refer to: Wheel and Tire (204-04A Wheels and Tires, Removal and Installation)...
Lincoln Navigator 2018-2026 Workshop Manual: Electronic Engine Controls - System Operation and Component Description. Description and Operation
System Operation Auto Start Stop The auto start stop system helps reduce fuel consumption and decrease emissions by automatically shutting down the engine when the vehicle stops and the engine is idling, usually within 1500 ms (1.5 seconds)...
Categories
- Manuals Home
- 4th Gen Lincoln Navigator Service Manual (2018 - 2026)
- Brake Service Mode Activation and Deactivation. General Procedures
- Power Running Board (PRB). Diagnosis and Testing
- Body and Paint
- Vehicle Dynamics Control Module (VDM). Removal and Installation
- Identification Codes. Description and Operation
Front Stabilizer Bar Link. Removal and Installation
Removal
NOTICE: Suspension fasteners are critical parts that affect the performance of vital components and systems. Failure of these fasteners may result in major service expense. Use the same or equivalent parts if replacement is necessary. Do not use a replacement part of lesser quality or substitute design. Tighten fasteners as specified.
NOTE: Removal steps in this procedure may contain installation details.
With the vehicle in NEUTRAL, position it on a hoist.Refer to: Jacking and Lifting (100-02 Jacking and Lifting, Description and Operation).
NOTICE: Do not use power tools to remove or install the stabilizer bar
