Lincoln Navigator: Engine Cooling - 3.5L EcoBoost (272kW/370PS) / Specifications
Coolant Capacity: Vehicles Built Up To: 08-July-2018
| Name | Fill Capacity |
| Material: Motorcraft® Orange Concentrated Antifreeze/Coolant / VC-3-B (WSS-M97B44-D) | Base radiator — 18.5 qt (17.5L), Heavy duty trailer tow radiator — 18.0 qt (17.0L) |
| Material: Motorcraft® Orange Prediluted Antifreeze/Coolant / VC-3DIL-B (WSS-M97B44-D2) | Base radiator — 18.5 qt (17.5L), Heavy duty trailer tow radiator — 18.0 qt (17.0L) |
Coolant Capacity: Vehicles Built From 09-July-2018 and all service
| Name | Fill Capacity |
| Material: Motorcraft® Yellow Concentrated Antifreeze/Coolant / VC-13-G (WSS-M97B57-A1) | Base radiator — 18.5 qt (17.5L), Heavy duty trailer tow radiator — 18.0 qt (17.0L) |
| Material: Motorcraft® Yellow Prediluted Antifreeze/Coolant / VC-13DL-G (WSS-M97B57-A2) | Base radiator — 18.5 qt (17.5L), Heavy duty trailer tow radiator — 18.0 qt (17.0L) |
| Material: Motorcraft® Premium Cooling System Flush / VC-1 (ESR-M14P7-A) | – |
Antifreeze
| Percent Antifreeze/Coolant to Distilled Water | Freeze Protection |
|---|---|
| 42/58 | -14.8 °F ( -26 °C) |
| 58/42 (Extreme Cold Climates) | -57.9 °F ( -50 °C) |
Cooling System Pressure
| Complete cooling system maximim pressure | 145 kPa (21 psi) |
| Pressure relief cap | 145 kPa (21 psi) |
| Radiator pressure test (removed from the vehicle) | 138 kPa (20 psi) |
Thermostat Opening Temperatures
| Starts to open | 87.8 - 91.6°C (190 - 197°F) |
| Fully open | 103.1°C (217.6°F) |
Engine Cooling - Component Location. Description and Operation
NOTE:
Coolant temperature will vary with ambient temperature and load.
Temperatures shown are for ambient temperature of 38° C (100° F). Red
arrows indicate a temperature over 90° C (194° F), Orange arrows
indicate a temperature of approximately 90° C (194° F), Blue arrows
indicate a temperature below 90° C (194° F)...
Other information:
Lincoln Navigator 2018-2026 Workshop Manual: Front Door Side Impact Sensor. Removal and Installation
Removal WARNING: The following procedure prescribes critical repair steps required for correct restraint system operation during a crash. Follow all notes and steps carefully. Failure to follow step instructions may result in incorrect operation of the restraint system and increases the risk of serious personal injury or death in a crash...
Lincoln Navigator 2018-2026 Workshop Manual: Wheel to Hub Runout Minimization. General Procedures
Check NOTE: Wheel-to-hub optimization is important. Clearance between the wheel and hub can be used to offset or neutralize the Road Force® or run-out of the wheel and tire assembly. For every 0.001 inch of wheel-to-hub clearance, the Road Force® can be affected between 1 and 3 pounds depending on the tire stiffness...
Categories
- Manuals Home
- 4th Gen Lincoln Navigator Service Manual (2018 - 2026)
- Transmission Fluid Level Check. General Procedures
- Brake Service Mode Activation and Deactivation. General Procedures
- All Terrain Control Module (ATCM). Removal and Installation
- Rear Bumper. Removal and Installation
- Liftgate Trim Panel. Removal and Installation
Axle Tube Bearing. Removal and Installation
Special Tool(s) / General Equipment
205-123
(T78P-1177-A)
Installer, Axle Shaft Oil Seal
308-047
(T77F-1102-A)
Remover, Bearing Cup Slide Hammer
