Lincoln Navigator: Roof Opening Panel / Roof Opening Panel Fixed Glass. Removal and Installation
Removal
NOTE:
Removal steps in this procedure may contain installation details.
-
Remove the roof opening panel frame.
Refer to: Roof Opening Panel Frame (501-17 Roof Opening Panel, Removal and Installation).
-
NOTE:
Position the roof opening panel frame upside down on a suitable workbench.
Remove the the roof opening panel fixed glass bolts and
with the aid of an assistant, separate the frame from the glass.
Torque:
35 lb.in (4 Nm)
Installation
-
To install, reverse the removal procedure.
Removal
The roof opening panel switch is replaced as an assembly with the overhead console.
Refer to: Overhead Console (501-12 Instrument Panel and Console, Removal and Installation)...
Special Tool(s) /
General Equipment
Flat-Bladed Screwdriver
Removal
NOTE:
Removal steps in this procedure may contain installation details...
Other information:
The front drive axle consists of:
A cast-aluminum center section, a removable cast-aluminum
axle housing tube and a differential housing cover. Both the axle
housing tube and the differential housing cover use silicone sealant as a
gasket...
The 9.75-inch ring gear rear conventional differential has 3.31 and 3.73 gear ratio versions.
The 9.75-inch ring gear rear differential with eLSD has 3.73 gear ratio.
Rear Drive Axle and Differential
The rear axle assembly consists of the following:
Integral-type housing hypoid gear design (center of the pinion set below the centerline of the ring gear)
Hypoid differentia..