Lincoln Navigator: Roof Opening Panel / Roof Opening Panel Control Switch. Removal and Installation

Lincoln Navigator 2018-2026 Workshop Manual / Body and Paint / Roof Opening Panel / Roof Opening Panel Control Switch. Removal and Installation

Removal

The roof opening panel switch is replaced as an assembly with the overhead console.
Refer to: Overhead Console (501-12 Instrument Panel and Console, Removal and Installation).

Installation

To install, reverse the removal procedure.

Air Deflector. Removal and Installation

Special Tool(s) / General Equipment Rivet Gun Electric Drill 6 mm Drill Bit Punch Vacuum Cleaner Removal NOTE: Removal steps in this procedure may contain installation details...

Roof Opening Panel Fixed Glass. Removal and Installation

Removal NOTE: Removal steps in this procedure may contain installation details. Remove the roof opening panel frame. Refer to: Roof Opening Panel Frame (501-17 Roof Opening Panel, Removal and Installation)...

Other information:

Lincoln Navigator 2018-2026 Workshop Manual: Power Steering - System Operation and Component Description. Description and Operation

System Operation System Diagram *.sttxt { visibility: hidden; } *.stcallout { visibility: visible; } ..

Lincoln Navigator 2018-2026 Workshop Manual: Seatbelt Twisted at the Seatbelt Guide. General Procedures

Adjustment NOTE: Typical D-ring shown, others similar. If required, remove the necessary trim panel(s). Fold the seatbelt as indicated. Feed the folded portion of the seatbelt into the D-ring. Pull the seatbelt through the D-ring to remove the twist in the seatbelt. ..

Front Stabilizer Bar Link. Removal and Installation

Removal

NOTICE: Suspension fasteners are critical parts that affect the performance of vital components and systems. Failure of these fasteners may result in major service expense. Use the same or equivalent parts if replacement is necessary. Do not use a replacement part of lesser quality or substitute design. Tighten fasteners as specified.

NOTE: Removal steps in this procedure may contain installation details.

With the vehicle in NEUTRAL, position it on a hoist.
Refer to: Jacking and Lifting (100-02 Jacking and Lifting, Description and Operation).

NOTICE: Do not use power tools to remove or install the stabilizer bar