Lincoln Navigator: Electronic Engine Controls - 3.5L EcoBoost (272kW/370PS) / Oil Pressure Control Solenoid. Removal and Installation
Removal
NOTE:
Removal steps in this procedure may contain installation details.
-
Remove the engine front cover.
Refer to: Engine Front Cover (303-01 Engine - 3.5L EcoBoost (272kW/370PS), Removal and Installation).
-
Remove oil pressure control solenoid.
Torque:
89 lb.in (10 Nm)
Installation
-
To install, reverse the removal procedure.
Removal
Remove the engine appearance cover retainers, release
the engine appearance cover from the rear retainers and then remove the
engine appearance cover...
Special Tool(s) /
General Equipment
Ford Diagnostic Equipment
Removal
NOTE:
Removal steps in this procedure may contain installation details...
Other information:
Removal
NOTE:
Removal steps in this procedure may contain installation details.
NOTE:
If installing a new module, it is necessary to
upload the module configuration information to the scan tool prior to
removing the module. This information must be downloaded into the new
module after installation...
Special Tool(s) /
General Equipment
Two Leg Puller
Removal
NOTE:
Removal steps in this procedure may contain installation details.
NOTE:
Make sure rear wiper is in the PARK position.
Open the wiper pivot arm nut cover...