Lincoln Navigator: Automatic Transmission External Controls / External Controls - Component Location. Description and Operation
| Item | Description |
|---|---|
| 1 | GSM |
| Item | Description |
|---|---|
| 1 | Downshift paddle switch |
| 2 | Upshift paddle switch |
External Controls - Overview. Description and Operation
The shift by wire system uses a push button GSM which interfaces with the PCM to select gear positions.
The shift by wire system also includes a brake shift interlock that
will not allow the transmission to shift out of P unless the brake pedal
is applied...
Other information:
Lincoln Navigator 2018-2026 Workshop Manual: Accessory Drive Belt. Removal and Installation
Removal With the vehicle in NEUTRAL, position it on a hoist. Refer to: Jacking and Lifting (100-02 Jacking and Lifting, Description and Operation). Rotate the accessory drive belt tensioner counter clockwise and remove the accessory drive belt...
Lincoln Navigator 2018-2026 Workshop Manual: Seatbelt Systems. Diagnosis and Testing
Global Customer Symptom Code (GCSC) Chart Diagnostics in this manual assume a certain skill level and knowledge of Ford-specific diagnostic practices. REFER to: Diagnostic Methods (100-00 General Information, Description and Operation). Symptom Action Driver Aid & Information > Warning Indicators/Messages/Chimes > Safety Belt > Inoperative GO to Pinpoint..
Categories
- Manuals Home
- 4th Gen Lincoln Navigator Service Manual (2018 - 2026)
- Transmission Fluid Level Check. General Procedures
- Liftgate Trim Panel. Removal and Installation
- Remote Function Actuator (RFA) Module. Removal and Installation
- Body and Paint
- Neutral Flat Tow Activation and Deactivation. General Procedures
Front Stabilizer Bar Link. Removal and Installation
Removal
NOTICE: Suspension fasteners are critical parts that affect the performance of vital components and systems. Failure of these fasteners may result in major service expense. Use the same or equivalent parts if replacement is necessary. Do not use a replacement part of lesser quality or substitute design. Tighten fasteners as specified.
NOTE: Removal steps in this procedure may contain installation details.
With the vehicle in NEUTRAL, position it on a hoist.Refer to: Jacking and Lifting (100-02 Jacking and Lifting, Description and Operation).
NOTICE: Do not use power tools to remove or install the stabilizer bar
