Lincoln Navigator: Evaporative Emissions - 3.5L EcoBoost (272kW/370PS) / Evaporative Emissions - Overview. Description and Operation
Overview
The EVAP system prevents hydrocarbon emissions from entering the atmosphere by storing fuel vapors and routing the vapors to the engine to be consumed during normal engine operation.
The EVAP system consists of:
- EVAP canister
- EVAP canister purge valve
- EVAP canister vent solenoid
- Fuel Tank Pressure (FTP) sensor and tube
- Easy Fuel (capless) fuel tank filler pipe
Evaporative Emissions - System Operation and Component Description. Description and Operation
System Operation
System Diagram
Item
Description
1
LH Valve cover
2
Air Cleaner outlet pipe
3
EVAP canister purge valve
4
Upper intake manifold
5
PCV
6
RH valve cover
7
EVAP canister
8
Vapor blocking valve
9
Fuel Tank Pressure (F..
Other information:
Lincoln Navigator 2018-2026 Workshop Manual: Keyless Entry Rear Antenna. Removal and Installation
Removal NOTE: Short wheelbase shown, long wheelbase similar. Position the liftgate weatherstrip aside. Release the clips and remove the liftgate scuff plate trim panel. Remove the load floor cover. Position the load floor storag..
Lincoln Navigator 2018-2026 Workshop Manual: Cylinder Head Distortion. General Procedures
Special Tool(s) / General Equipment Feeler Gauge Check NOTE: Refer to the appropriate Section 303-01 for the specification. NOTE: Make sure all cylinder head surfaces are clear of any gasket material, silicone sealant, oil and coolant. The cylinder head surface must be clean and dry before running a flatness check. NOTE: Use a Straightedge th..
Categories
- Manuals Home
- 4th Gen Lincoln Navigator Service Manual (2018 - 2026)
- Power Running Board (PRB). Diagnosis and Testing
- Vehicle Dynamics Control Module (VDM). Removal and Installation
- All Terrain Control Module (ATCM). Removal and Installation
- Telematics Control Unit (TCU) Module. Removal and Installation
- Windshield Washer Pump. Removal and Installation
Rear Stabilizer Bar Link. Removal and Installation
Removal
NOTE: Removal steps in this procedure may contain installation details.
With the vehicle in NEUTRAL, position it on a hoist.Refer to: Jacking and Lifting (100-02 Jacking and Lifting, Description and Operation).
NOTE: Use the hex-holding feature to prevent the stud from turning while removing the nut.
Remove and discard the 2 rear stabilizer bar link nuts and remove the rear stabilizer bar link.Torque: 46 lb.ft (63 Nm)
