Lincoln Navigator: Accessory Drive - 3.5L EcoBoost (272kW/370PS) / Accessory Drive Belt Tensioner. Removal and Installation
Removal
NOTE: Removal steps in this procedure may contain installation details.
-
Remove the accessory drive belt.
Refer to: Accessory Drive Belt (303-05C) .
-
Remove the bolts and the accessory drive belt tensioner.
Torque: 18 lb.ft (25 Nm)
 |
Installation
-
To install, reverse the removal procedure.
Accessory Drive Belt. Removal and Installation
Removal
With the vehicle in NEUTRAL, position it on a hoist.
Refer to: Jacking and Lifting (100-02 Jacking and Lifting, Description and Operation)...
Other information:
Lincoln Navigator 2018-2026 Workshop Manual: Axle Tube Bearing. Removal and Installation
Special Tool(s) / General Equipment 205-123 (T78P-1177-A) Installer, Axle Shaft Oil Seal 308-047 (T77F-1102-A) Remover, Bearing Cup Slide Hammer Removal Remove the axle shaft seal. Refer to: Axle Shaft Seal (205-03 Front Drive Axle/Differential, Removal and Installation)...
Lincoln Navigator 2018-2026 Workshop Manual: Exterior Rear Door Handle. Removal and Installation
Removal NOTE: LH side shown, RH side similar. NOTE: Removal steps in this procedure may contain installation details. Remove the rear door trim panel. Refer to: Rear Door Trim Panel (501-05 Interior Trim and Ornamentation, Removal and Installation)...
Categories
- Manuals Home
- 4th Gen Lincoln Navigator Service Manual (2018 - 2026)
- Brake Service Mode Activation and Deactivation. General Procedures
- Remote Function Actuator (RFA) Module. Removal and Installation
- Body Control Module (BCM). Removal and Installation
- Vehicle Dynamics Control Module (VDM). Removal and Installation
- Head Up Display (HUD) Module Calibration. General Procedures
Diagnostic Methods. Description and Operation
This document provides critical diagnostic knowledge required for successful repair outcomes. It identifies technical competencies expected by users of this manual.
Ford Diagnostic Assumptions
Ford diagnostics assume the vehicle concern described by the test title is currently present. Exceptions to this rule are noted in each test. Do not replace modules or other components as directed by a diagnostic if the concern is not present at the time of testing.
