Lincoln Navigator: Third Row Seats / Third Row Single Seat Backrest. Removal and Installation
Removal
-
Remove the third row single seat backrest cover.
Refer to: Third Row Single Seat Backrest Cover (501-10C) .
-
Remove the third row single seat frame.
Refer to: Third Row Single Seat Frame (501-10C Third Row Seats, Removal and Installation).
Installation
-
NOTE: Transfer components to the new third row double seat backrest as necessary.
To install, reverse the removal procedure.
Third Row Seat Head Restraint Guide Sleeve. Removal and Installation
Special Tool(s) /
General Equipment
Flat Headed Screw Driver
Removal
NOTE:
Double seat shown, single seat similar.
Remove the third row seat head restraint(s)...
Third Row Single Seat Backrest Cover. Removal and Installation
Removal
Remove the third row seat head restraint guide sleeves.
Refer to: Third Row Seat Head Restraint Guide Sleeve (501-10C Third Row Seats, Removal and Installation)...
Other information:
Lincoln Navigator 2018-2026 Workshop Manual: Front Seat Control Switch. Removal and Installation
Removal NOTE: LH shown, RH similar. Remove the front door trim panel. Refer to: Front Door Trim Panel (501-05 Interior Trim and Ornamentation, Removal and Installation). Disconnect the front seat control switch and speaker electrical connectors...
Lincoln Navigator 2018-2026 Workshop Manual: Rear Halfshaft Seal. Removal and Installation
Special Tool(s) / General Equipment 205-907Handle, 32 DriverTKIT-2008DH-FLM 206-034 (T88P-20202-B) Installer, Wheel Speed Sensor RingTKIT-1988-FLMTKIT-1988-LM Feeler Gauge Removal NOTE: Removal steps in this procedure may contain installation details...
Categories
- Manuals Home
- 4th Gen Lincoln Navigator Service Manual (2018 - 2026)
- Rear View Mirrors - System Operation and Component Description. Description and Operation
- Rear Bumper. Removal and Installation
- All Terrain Control Module (ATCM). Removal and Installation
- Head Up Display (HUD) Module Calibration. General Procedures
- Identification Codes. Description and Operation
Rear Drive Halfshafts. Diagnosis and Testing
Preliminary Inspection
Visually inspect the CV joints, housing, boots, and clamps for obvious signs of mechanical damage.If an obvious cause for an observed or reported concern is found, correct the cause (if possible) before proceeding to the next step
If the cause is not visually evident, verify the symptom and REFER to Symptom Chart: NVH.
