Lincoln Navigator: Generator and Regulator / Specifications
General Specifications
| Item | Specification |
|---|---|
| Rating | 260 amps |
| Generator amps at 80.6 °F ( 27 °C) | 165 amps at 700 rpm (min) to 260 amps at 2,300 rpm (max) |
| Generator pulley ratio | 2.67:1 |
| Generator pulley replaceable | Yes |
| Generator pulley type | Overrunning Alternator Decoupler (OAD) |
| Voltage regulator type | Electronic internal with generator (LIN) |
Generator. Removal and Installation
Removal
NOTE:
Removal steps in this procedure may contain installation details.
With the vehicle in NEUTRAL, position it on a hoist...
Other information:
Lincoln Navigator 2018-2026 Workshop Manual: Outer Constant Velocity (CV) Joint Boot. Removal and Installation
Special Tool(s) / General Equipment Flat Headed Screw Driver Boot Clamp Pliers Removal Remove the inner CV joint boot. Refer to: Inner Constant Velocity (CV) Joint Boot (205-04 Front Drive Halfshafts, Removal and Installation)...
Lincoln Navigator 2018-2026 Workshop Manual: Output Shaft Speed (OSS) Sensor. Removal and Installation
Removal Remove the main control valve body. Refer to: Main Control Valve Body (307-01 Automatic Transmission - 10-Speed Automatic Transmission – 10R80, Removal and Installation). Remove the OSS sensor. Slide the plastic lock to the unlocked position...
Categories
- Manuals Home
- 4th Gen Lincoln Navigator Service Manual (2018 - 2026)
- Remote Function Actuator (RFA) Module. Removal and Installation
- Rear View Mirrors - System Operation and Component Description. Description and Operation
- Rear Bumper. Removal and Installation
- SYNC Module [APIM]. Removal and Installation
- Identification Codes. Description and Operation
Diagnostic Methods. Description and Operation
This document provides critical diagnostic knowledge required for successful repair outcomes. It identifies technical competencies expected by users of this manual.
Ford Diagnostic Assumptions
Ford diagnostics assume the vehicle concern described by the test title is currently present. Exceptions to this rule are noted in each test. Do not replace modules or other components as directed by a diagnostic if the concern is not present at the time of testing.
