Lincoln Navigator: Brake System - General Information / Specifications
Lubricants, Fluids, Sealers and Adhesives
| Specifications | |
|---|---|
| Motorcraft® DOT 4 LV High Performance Motor Vehicle Brake Fluid / PM-20 | WSS-M6C65-A2 |
Torque Specifications
| Item | Nm | lb-ft | lb-in |
|---|---|---|---|
| Front caliper bleeder screw | 10 | - | 89 |
| Rear caliper bleeder screw | 10 | - | 89 |
| EBB brake tube fitting | 20 | - | 177 |
General Specifications
| Item | Specification |
|---|---|
| Front brake disc minimum thickness | 1.280 in ( 32.5 mm) |
| Rear brake disc minimum thickness (vehicles with electronic parking brake) | 0.728 in ( 18.5 mm) |
| Brake pad minimum thickness | 0.059 in ( 1.5 mm) |
| Brake pad maximum taper wear (in any direction) | 0.059 in ( 1.5 mm) |
Brake System. Diagnosis and Testing
Global Customer Symptom Code (GCSC) Chart
Diagnostics in this manual assume a certain skill level and knowledge of Ford-specific diagnostic practices...
Other information:
Lincoln Navigator 2018-2026 Workshop Manual: Accessory Drive. Diagnosis and Testing
Inspection and Verification Verify the customer concern. Visually inspect for obvious signs of mechanical damage. Visual Inspection Chart Mechanical Damaged or contaminated accessory drive belt Damaged or contaminated pulley(s) Incorrect accessory drive belt Incorrect fitment of t..
Lincoln Navigator 2018-2026 Workshop Manual: Compression and Cylinder Leakage Test. General Procedures
Make sure the oil in the crankcase is of the correct viscosity and at the correct level and that the battery is correctly charged. Operate the vehicle until the engine is at normal operating temperature. Turn the ignition switch to the OFF position. Remove the spark plugs. For additional information, refer to: Spark Plugs (303-07 Engine Ignition - 3.5L EcoBoost (27..
Categories
- Manuals Home
- 4th Gen Lincoln Navigator Service Manual (2018 - 2026)
- Transmission Fluid Level Check. General Procedures
- Identification Codes. Description and Operation
- Windshield Washer Pump. Removal and Installation
- SYNC Module [APIM]. Removal and Installation
- Rear View Mirrors - System Operation and Component Description. Description and Operation
Differential Case Runout Check. General Procedures
Special Tool(s) / General Equipment
205-1016Installer, Differential Bearing
TKIT-2014D-ROW2
TKIT-2014D-FL_ROW
205-153
(T80T-4000-W)
Handle
205-D061
(D83T-4205-C2)
Step Plate Dial Indicator Three Leg Puller Punch
