Lincoln Navigator: Hydraulic Brake Actuation / Hydraulic Brake Actuation - Overview. Description and Operation
Overview – Adjustable Pedals
The adjustable pedal feature uses an electrical motor to adjust the brake and accelerator pedal positions forward and rearward to increase driver comfort. This is accomplished through the use of the adjustable pedal switch, the memory set switch (if equipped) or the RKE transmitter (if equipped).
Hydraulic Brake Actuation - System Operation and Component Description. Description and Operation
System Operation
System Diagram – Adjustable Pedals
*.sttxt {
visibility: hidden;
}
*.stcallout {
visibility: visible;
}
1
Adjustable Pedal
Motor
E344587
2
RKE
..
Other information:
Lincoln Navigator 2018-2026 Workshop Manual: Driver Side Register Air Discharge Temperature Sensor. Removal and Installation
Special Tool(s) / General Equipment Interior Trim Remover Removal NOTE: Removal steps in this procedure may contain installation details. Remove the sunload sensor and disconnect the electrical connector. Use the General Equipment: Interior Trim Remover Release the clips and remove the instrument panel c..
Lincoln Navigator 2018-2026 Workshop Manual: Brake Fluid Reservoir. Removal and Installation
Removal NOTE: Removal steps in this procedure may contain installation details. Remove the EBB . Refer to: Electric Brake Booster (EBB) (206-09 Anti-Lock Brake System (ABS) and Stability Control, Removal and Installation). Remove the brake fluid reservoir cap. Remove the brake fluid reservoir filter a..
Categories
- Manuals Home
- 4th Gen Lincoln Navigator Service Manual (2018 - 2026)
- Windshield Washer Pump. Removal and Installation
- Liftgate Trim Panel. Removal and Installation
- Body and Paint
- Transmission Fluid Level Check. General Procedures
- SYNC Module [APIM]. Removal and Installation
Front Stabilizer Bar Link. Removal and Installation
Removal
NOTICE: Suspension fasteners are critical parts that affect the performance of vital components and systems. Failure of these fasteners may result in major service expense. Use the same or equivalent parts if replacement is necessary. Do not use a replacement part of lesser quality or substitute design. Tighten fasteners as specified.
NOTE: Removal steps in this procedure may contain installation details.
With the vehicle in NEUTRAL, position it on a hoist.Refer to: Jacking and Lifting (100-02 Jacking and Lifting, Description and Operation).
NOTICE: Do not use power tools to remove or install the stabilizer bar
