• Navigator Manuals
  • Service
  • New
  • Top
  • Sitemap
Lincoln Navigator Manuals

Lincoln Navigator: Front End Body Panels / Hood. Removal and Installation

Lincoln Navigator 2018-2026 Workshop Manual / Body and Paint / Front End Body Panels / Hood. Removal and Installation

Removal

NOTE: Removal steps in this procedure may contain installation details.

  1. NOTE: RH side shown, LH side similar.

    On both sides.
    Index-mark the hood hinge location to aid in hood installation.
  1. NOTICE: Support the hood before removing the strut. Failure to follow this direction may result in damage to the components.

    NOTICE: Use the correct service parts when replacing the hood struts. The hood struts are not interchangeable and using the incorrect service part will result in damage to components.

    Release the clips and remove the struts.
  1. NOTE: An assistant is necessary for the removal of the hood.

    Remove the nuts and the hood.
    Torque: 17 lb.ft (23 Nm)
  1. NOTE: This step is only necessary when installing a new component.

    Remove the retainers and hood insulation.
  1. NOTE: This step is only necessary when installing a new component.

    Remove the retainers and the hood pad assembly.
  1. NOTE: This step is only necessary when installing a new component.

    Remove the striker latch to hood bolts and the striker latch.
    Torque: 106 lb.in (12 Nm)

Installation

  1. To install, reverse the removal procedure.
  1. Check the hood alignment. Align the hood as necessary.
    Refer to: Hood Alignment (501-03 Body Closures, General Procedures).

    Fender Splash Shield. Removal and Installation

    Removal NOTE: LH side shown, RH side similar. Remove the wheel and tire. Refer to: Wheel and Tire (204-04A Wheels and Tires, Removal and Installation)...

    Body Closures

    ..

    Other information:

    Lincoln Navigator 2018-2026 Workshop Manual: Climate Control Tools and Equipment. General Procedures


    Climate Control Tools and Equipment Use the correct adapters with the Rotunda approved A/C Tools. NOTE: The climate control tools and equipment listed are regionally required for Ford North America A/C service repairs. Make sure to use regionally approved A/C tools and equipment that are based on regional and/or environmental requirements. ..

    Lincoln Navigator 2018-2026 Workshop Manual: Timing Chain Tensioner. Removal and Installation


    Special Tool(s) / General Equipment 303-1655Tool, Camshaft Holding Removal NOTICE: During engine repair procedures, cleanliness is extremely important. Any foreign material, including any material created while cleaning gasket surfaces, that enters the oil passages, coolant passages or the oil pan may cause engine failure. RH and LH tensioners ..

    Categories

    • Manuals Home
    • 4th Gen Lincoln Navigator Service Manual (2018 - 2026)
    • Power Running Board (PRB). Diagnosis and Testing
    • Identification Codes. Description and Operation
    • Liftgate Trim Panel. Removal and Installation
    • Brake Service Mode Activation and Deactivation. General Procedures
    • Rear Bumper. Removal and Installation

    Rear Drive Halfshafts. Diagnosis and Testing

    Preliminary Inspection

    Visually inspect the CV joints, housing, boots, and clamps for obvious signs of mechanical damage.
    If an obvious cause for an observed or reported concern is found, correct the cause (if possible) before proceeding to the next step
    If the cause is not visually evident, verify the symptom and REFER to Symptom Chart: NVH.

    read more

    Copyright © 2026 www.linavigator4.com