Lincoln Navigator: Engine - 3.5L EcoBoost (272kW/370PS) / Flexplate. Removal and Installation
Removal
-
Remove the transmission.
Refer to: Transmission (307-01 Automatic Transmission - 10-Speed Automatic Transmission – 10R80, Removal and Installation).
-
Remove the bolts and the flexplate.
 |
Installation
-
NOTE: The offset hole may be used in four locations.
Install the flexplate and the bolts. Tighten in sequence shown.
Torque: 59 lb.ft (80 Nm)
 |
-
Install the transmission.
Refer to: Transmission (307-01 Automatic Transmission - 10-Speed Automatic Transmission – 10R80, Removal and Installation).
-
After completing the repairs, perform the Misfire
Monitor Neutral Profile Correction procedure using a diagnostic scan
tool.
Exhaust Manifold RH. Removal and Installation
Materials
Name
Specification
Motorcraft® Metal Surface Prep WipesZC-31-B
-
Removal
With the vehicle in NEUTRAL, position it on a hoist...
Front Cover to Coolant Pipe Seal. Removal and Installation
Special Tool(s) /
General Equipment
303-1528Remover/Installer, Water Tube Seal
Removal
NOTICE:
During engine repair procedures, cleanliness is extremely
important...
Other information:
Lincoln Navigator 2018-2026 Workshop Manual: Cruise Control Radar Alignment. General Procedures
Special Tool(s) / General Equipment Interior Trim Remover Adjustment Vertical Alignment NOTE: In order to align the CCM , the front bumper trim panel must be removed to access the sensor and the vehicle must be in a wheel alignment bay station so that the vehicle is level...
Lincoln Navigator 2018-2026 Workshop Manual: Driver Status Monitor Camera Module [CMR]. Removal and Installation
Removal NOTE: If installing a new module, it is necessary to upload the module configuration information to the diagnostic scan tool prior to removing the module. This information must be downloaded into the new module after installation...
Categories
- Manuals Home
- 4th Gen Lincoln Navigator Service Manual (2018 - 2026)
- Rear View Mirrors - System Operation and Component Description. Description and Operation
- Front Seat. Removal and Installation
- Brake Service Mode Activation and Deactivation. General Procedures
- Body Control Module (BCM). Removal and Installation
- Windshield Washer Pump. Removal and Installation
Differential Case Runout Check. General Procedures
Special Tool(s) / General Equipment
205-1016Installer, Differential Bearing
TKIT-2014D-ROW2
TKIT-2014D-FL_ROW
205-153
(T80T-4000-W)
Handle
205-D061
(D83T-4205-C2)
Step Plate Dial Indicator Three Leg Puller Punch
