Lincoln Navigator: Battery, Mounting and Cables / Battery. Removal and Installation
Removal
NOTE: Removal steps in this procedure may contain installation details.
-
Disconnect the battery.
Refer to: Battery Disconnect and Connect (414-01 Battery, Mounting and Cables, General Procedures).
-
Fully loosen and remove the battery hold-down bolt and clamp. Remove the battery.
Torque: 62 lb.in (7 Nm)
 |
-
If installing a new battery, remove the battery heat shield.
 |
Installation
-
To install, reverse the removal procedure.
-
If installing a new battery, use the scan tool to carry
out the Battery Monitoring System (BMS) reset after the battery is
connected.
Battery Drain Check. General Procedures
Check
NOTE:
No factory-equipped vehicle should have more than a 25 mA
(0.025 amp) – 50 mA (0.050) draw depending on the vehicle's accessories...
Battery Cables. Removal and Installation
Removal
NOTE:
This procedure provides information about routing, retaining
points and connectors of the cable. It does not include the steps for
removing components to gain access to the cable...
Other information:
Lincoln Navigator 2018-2026 Workshop Manual: Flexplate. Removal and Installation
Removal Remove the transmission. Refer to: Transmission (307-01 Automatic Transmission - 10-Speed Automatic Transmission – 10R80, Removal and Installation). Remove the bolts and the flexplate. Installation NOTE: The offset hole may be used in four locations...
Lincoln Navigator 2018-2026 Workshop Manual: Direct Current/Direct Current (DC/DC) Converter Control Module. Diagnosis and Testing
Diagnostics in this manual assume a certain skill level and knowledge of Ford-specific diagnostic practices. REFER to: Diagnostic Methods (100-00 General Information, Description and Operation). Direct Current/Direct Current (DC/DC) Converter Control Module DTC Chart DTC Description Action P0A12:11 DC/D..
Categories
- Manuals Home
- 4th Gen Lincoln Navigator Service Manual (2018 - 2026)
- Brake Service Mode Activation and Deactivation. General Procedures
- Transmission Fluid Level Check. General Procedures
- Telematics Control Unit (TCU) Module. Removal and Installation
- Rear View Mirrors - System Operation and Component Description. Description and Operation
- Vehicle Dynamics Control Module (VDM). Removal and Installation
Rear Stabilizer Bar Link. Removal and Installation
Removal
NOTE: Removal steps in this procedure may contain installation details.
With the vehicle in NEUTRAL, position it on a hoist.Refer to: Jacking and Lifting (100-02 Jacking and Lifting, Description and Operation).
NOTE: Use the hex-holding feature to prevent the stud from turning while removing the nut.
Remove and discard the 2 rear stabilizer bar link nuts and remove the rear stabilizer bar link.Torque: 46 lb.ft (63 Nm)
