Lincoln Navigator: Wipers and Washers / Wipers and Washers - Overview. Description and Operation
Overview
The windshield wiper/washer system is activated by the wiper/washer switch. The following functions/ features of the windshield wiper/washer system are:
- Mist wipe
- Windshield wash (includes front camera wash, if equipped)
- Courtesy wipe
- Windshield wipers (low/high speed)
- Intermittent wipers
- Speed dependent wipers
- Wiper activated exterior lamps
- Rain sensitive wipers (if equipped)
- Rear window wipe/wash (includes rear camera wash, if equipped)
The intermittent/rain sensitive wipers have 7 intermittent/sensitivity settings.
Wipers and Washers - System Operation and Component Description. Description and Operation
System Operation
System Diagram
E363825
*.sttxt {
visibility: hidden;
}
*.stcallout {
visibility: visible;
}
1
Wiper relay
2
BJB
3
Rain Sensor
4
Rear Wiper Motor
5
Winds..
Other information:
Lincoln Navigator 2018-2026 Workshop Manual: Cylinder Block Core Plug Replacement. General Procedures
Special Tool(s) / General Equipment 100-001 (T50T-100-A) Slide Hammer Materials Name Specification Motorcraft® Threadlock 262TA-26 WSK-M2G351-A6 Repair All core plugs NOTE: Cylinder block core plug shown, cylinder head core plug similar. Using the Slide Hammer and a commercially available body dent puller att..
Lincoln Navigator 2018-2026 Workshop Manual: Body Control Module (BCM). Diagnosis and Testing
Diagnostic Trouble Code (DTC) Chart Diagnostics in this manual assume a certain skill level and knowledge of Ford-specific diagnostic practices. REFER to: Diagnostic Methods (100-00 General Information, Description and Operation). Module DTC Description Action BCM B11D8:01 Restraint Event Notification: General Electrical Failure GO to Pinpoint Test A BCM ..
Categories
- Manuals Home
- 4th Gen Lincoln Navigator Service Manual (2018 - 2026)
- Rear Bumper. Removal and Installation
- Transmission Fluid Drain and Refill. General Procedures
- Liftgate Trim Panel. Removal and Installation
- Body Control Module (BCM). Removal and Installation
- Telematics Control Unit (TCU) Module. Removal and Installation
Differential Case Runout Check. General Procedures
Special Tool(s) / General Equipment
205-1016Installer, Differential Bearing
TKIT-2014D-ROW2
TKIT-2014D-FL_ROW
205-153
(T80T-4000-W)
Handle
205-D061
(D83T-4205-C2)
Step Plate Dial Indicator Three Leg Puller Punch
