Lincoln Navigator: Steering Wheel and Column Electrical Components / Steering Wheel Multifunction Switch. Removal and Installation
Removal
NOTE:
High series shown, others similar.
-
Remove the driver airbag.
Refer to: Driver Airbag (501-20B Supplemental Restraint System, Removal and Installation).
-
On both sides.
Disconnect the steering wheel switch electrical connectors.
-
-
Remove the steering wheel switch bezel retainers.
-
Using a suitable flat-bladed tool, remove the steering wheel switch bezel.
-
Remove the retainers and the upper steering wheel multifunction switch.
-
Remove the retainers and the lower steering wheel multifunction switch.
Installation
-
To install, reverse the removal procedure.
Removal
NOTE:
Removal steps in this procedure may contain installation details.
Remove the steering column shrouds.
Refer to: Steering Column Shrouds (501-05 Interior Trim and Ornamentation, Removal and Installation)...
Other information:
Special Tool(s) /
General Equipment
6.5 mm Drill Bit
Grinder
Self-Piercing Rivet (SPR) Remover/Installer
Belt Sander
Knife
Locking Pliers
Materials
Name
Specification
Metal Bonding AdhesiveTA-1, TA-1-B, 3M™ 08115, LORD Fusor® 108B, Henkel Teroson EP 5055
-
Roof Ditch Sealer3M™ 08307, LORD Fusor® 129
..
Check
NOTE:
This procedure does not apply to CV joints, flex couplers or
double cardan joints that are used in some driveshafts. This check is
for single-cross and roller-style joints found in the driveshafts.
NOTE:
Prior to checking driveline angularity, inspect the U-joints for correct operation.
NOTE:
An incorrect driveline angle can cause a vibration or shudder.
N..