Lincoln Navigator: Power Brake Actuation / Power Brake System - Overview. Description and Operation
Electric Brake Boost
Overview
The power assisted brake system utilizes an EBB . The EBB is an integrated function of the ABS / HCU assembly and is controlled by the ABS module. The ABS / HCU combines the functions of a conventional vacuum booster and ABS module. The ABS module controls and monitors the EBB function and sets Diagnostic Trouble Codes (DTCs) when a fault is present in the system. The IPC illuminates the red brake warning indicator and displays a message in the message center when a fault is present.
Power Brake System - System Operation and Component Description. Description and Operation
System Operation
System Diagram - Electric Brake Boost
E373069
*.sttxt {
visibility: hidden;
}
*.stcallout {
visibility: visible;
}
HS-CAN3
HS-CAN1
HS-CAN2
1
IPC
2
RCM
..
Other information:
Lincoln Navigator 2018-2026 Workshop Manual: Head Up Display (HUD) Module. Removal and Installation
Removal NOTE: Removal steps in this procedure may contain installation details. Remove the instrument panel. Refer to: Instrument Panel (501-12 Instrument Panel and Console, Removal and Installation). Disconnect the electrical connector, remove the bolts and the HUD module. Torque: 80 lb.in (9 Nm) Install..
Lincoln Navigator 2018-2026 Workshop Manual: Second Row Seats - Overview. Description and Operation
Overview Power E-Z Entry Seats While the rear passenger door is open, pressing and releasing the LH or RH rear seat control switch (located at the back of the rear door opening) causes the corresponding rear seat to pitch and slide forward for access to the third row seating. Power-Folding Seats Pressing and releasing the rear seat control switch (located in the rear cargo ..
Categories
- Manuals Home
- 4th Gen Lincoln Navigator Service Manual (2018 - 2026)
- Transmission Fluid Drain and Refill. General Procedures
- Rear Bumper. Removal and Installation
- Identification Codes. Description and Operation
- Power Running Board (PRB). Diagnosis and Testing
- Vehicle Dynamics Control Module (VDM). Removal and Installation
Rear Drive Halfshafts. Diagnosis and Testing
Preliminary Inspection
Visually inspect the CV joints, housing, boots, and clamps for obvious signs of mechanical damage.If an obvious cause for an observed or reported concern is found, correct the cause (if possible) before proceeding to the next step
If the cause is not visually evident, verify the symptom and REFER to Symptom Chart: NVH.
