• Navigator Manuals
  • Service
  • New
  • Top
  • Sitemap
Lincoln Navigator Manuals

Lincoln Navigator: Accessory Drive - 3.5L EcoBoost (272kW/370PS) / Accessory Drive - Component Location. Description and Operation

Lincoln Navigator 2018-2026 Workshop Manual / Engine / Accessory Drive - 3.5L EcoBoost (272kW/370PS) / Accessory Drive - Component Location. Description and Operation


Item Description
1 Coolant pump pulley
2 Accessory drive belt
3 Generator pulley
4 Accessory drive belt idler pulley
5 A/C compressor belt
6 Crankshaft pulley
7 A/C compressor Pulley
8 Accessory drive belt tensioner

    Accessory Drive - 3.5L EcoBoost (272kW/370PS)

    ..

    Accessory Drive. Diagnosis and Testing

    Inspection and Verification Verify the customer concern. Visually inspect for obvious signs of mechanical damage.   Visual Inspection Chart Mechanical Damaged or contaminated accessory drive belt Damaged or contaminated pulley(s) Incorrect accessory drive belt Incorrect fitment of t..

    Other information:

    Lincoln Navigator 2018-2026 Workshop Manual: Tie Rod End. Removal and Installation


    Special Tool(s) / General Equipment Tie Rod End Remover Removal NOTE: Removal steps in this procedure may contain installation details. NOTICE: Disconnect the battery ground cable anytime the steering linkage is being serviced or damage to the steering gear may occur resulting in steering gear replacement. Disconnect the battery ground cable...

    Lincoln Navigator 2018-2026 Workshop Manual: Complete Panel Replacement/Partial Replacement. Description and Operation


    Partial Replacement Item Description 1 Sectioning area 2 Manufacture weld joint Decision Criteria The following points a crucial to the decision of complete or partial replacement of the part(s). Is the repair economically feasible. Retenti..

    Categories

    • Manuals Home
    • 4th Gen Lincoln Navigator Service Manual (2018 - 2026)
    • Telematics Control Unit (TCU) Module. Removal and Installation
    • All Terrain Control Module (ATCM). Removal and Installation
    • Identification Codes. Description and Operation
    • Transmission Fluid Level Check. General Procedures
    • Vehicle Dynamics Control Module (VDM). Removal and Installation

    Front Driveshaft. Removal and Installation

    Special Tool(s) / General Equipment

    Crimping Tool

    Materials

    Name Specification Motorcraft® Premium Long-Life Grease
    XG-1-E1 ESA-M1C75-B
     

    Removal

    With the vehicle in NEUTRAL, position the vehicle on a hoist.
    Refer to: Jacking and Lifting (100-02 Jacking and Lifting, Description and Operation).
    Remove the bolts and the transmission shield.

    read more

    Copyright © 2026 www.linavigator4.com