Lincoln Navigator: Exterior Lighting / Headlamp Switch. Removal and Installation
Special Tool(s) /
General Equipment
Removal
NOTE:
Removal steps in this procedure may contain installation details.
-
Release the clips and remove the steering column opening trim panel.
-
Release the clips and remove the LH instrument panel finish panel.
Use the General Equipment: Interior Trim Remover
-
Release the clips and remove the upper LH instrument panel finish panel.
Use the General Equipment: Interior Trim Remover
-
Remove the bolts and the LH trim panel.
-
Disconnect the electrical connectors.
Torque:
22 lb.in (2.5 Nm)
-
Release the tabs and remove the headlamp switch.
Installation
-
To install, reverse the removal procedure.
Removal
NOTE:
Removal steps in this procedure may contain installation details.
NOTE:
If installing a new HCM (headlamp control module),
it is necessary to upload the module configuration information to the
scan tool prior to removing the module...
Removal
Remove the rear spoiler.
Refer to: Rear Spoiler (501-08 Exterior Trim and Ornamentation, Removal and Installation).
Remove the bolts and the high mounted stop lamp assembly...
Other information:
Removal
NOTE:
Driver seat shown, passenger seat similar.
Remove the front seat cushion cover.
Refer to: Front Seat Cushion Cover (501-10A Front Seats, Removal and Installation).
Remove the pin-type retainers and the front seat cushion bolster(s)...
Removal
Remove the main control valve body.
Refer to: Main Control Valve Body (307-01 Automatic Transmission -
10-Speed Automatic Transmission – 10R80, Removal and Installation).
Remove the intermediate speed sensor B...