Lincoln Navigator: Front End Body Panels / Engine Front Undershield. Removal and Installation

Lincoln Navigator 2018-2026 Workshop Manual / Body and Paint / Front End Body Panels / Engine Front Undershield. Removal and Installation

NOTE: 4X2 vehicle shown, 4X4 vehicle similar.
If equipped,
Remove the bolts and the underbody skid plate.
Torque: 30 lb.ft (40 Nm)

If equipped,
Remove the bolts and the underbody skid plate.
Torque: 30 lb.ft (40 Nm)

Cowl Panel Grille. Removal and Installation

Removal Both sides Remove the wiper pivot arm. Refer to: Windshield Wiper Pivot Arm (501-16 Wipers and Washers, Removal and Installation)...

Engine Rear Undershield. Removal and Installation

NOTICE: Support the engine rear undershield while the fasteners are being removed and installed. Do not support the engine rear undershield by any less than the total number of fasteners at any time...

Other information:

Lincoln Navigator 2018-2026 Workshop Manual: Specifications

General Specifications Item Specification Spark plug 12405 Spark plug gap 0.030 in ( .75 mm) ..

Lincoln Navigator 2018-2026 Workshop Manual: Passenger Airbag. Removal and Installation

Removal WARNING: The following procedure prescribes critical repair steps required for correct supplemental restraint system operation during a crash. Follow all notes and steps carefully. Failure to follow step instructions may result in incorrect operation of the supplemental restraint system and increases the risk of serious personal injury or death in a crash. ..

Rear Stabilizer Bar Link. Removal and Installation

Removal

NOTE: Removal steps in this procedure may contain installation details.

With the vehicle in NEUTRAL, position it on a hoist.
Refer to: Jacking and Lifting (100-02 Jacking and Lifting, Description and Operation).

NOTE: Use the hex-holding feature to prevent the stud from turning while removing the nut.

Remove and discard the 2 rear stabilizer bar link nuts and remove the rear stabilizer bar link.
Torque: 46 lb.ft (63 Nm)