Lincoln Navigator: Battery, Mounting and Cables / Battery and Cables - System Operation and Component Description. Description and Operation
System Operation
Battery and Cables
The battery and cable system consists of the following components:
- Battery
- Battery tray
- Battery monitoring sensor
- Negative battery cable
- Positive battery cable
- High current BJB
Vehicles are equipped with a 12-volt, maintenance-free battery. The battery is a 12-volt DC source connected in a negative ground system and is a voltage stabilizer for the 12-volt electrical system.
A battery monitoring sensor is attached to the negative side of the battery cable,
Refer
to: Charging System - 3.5L EcoBoost (272kW/370PS) - System Operation
and Component Description (414-00 Charging System - General Information,
Description and Operation).
Ford Motor Company strongly recommends that all faulty lead-acid batteries be returned to an authorized recycling facility for disposal.
Battery. Diagnosis and Testing
General Equipment
Diagnostic Battery Charger
Use Ford approved battery test equipment listed in the Ford Warranty and Policy Manual...
Other information:
Lincoln Navigator 2018-2025 Workshop Manual: B Clutch. Description and Operation
Overview Item Description 1 SSB 2 B clutch control valve 3 B clutch latch valve 4 B clutch apply circuit 5 B clutch piston 6 B clutch assembly 7 One-Way Clutch (OWC) ..
Lincoln Navigator 2018-2025 Workshop Manual: Wireless Accessory Charging Module (WACM). Removal and Installation
Special Tool(s) / General Equipment Interior Trim Remover Removal NOTE: If installing a new module, it is necessary to upload the module configuration information to the scan tool prior to removing the module. This information must be downloaded into the new module after installation. Using a diagnostic scan tool, begin the PMI process for the WACM follo..
Categories
- Manuals Home
- 4th Gen Lincoln Navigator Service Manual (2018 - 2025)
- All Terrain Control Module (ATCM). Removal and Installation
- Transmission Fluid Level Check. General Procedures
- Rear View Mirrors - System Operation and Component Description. Description and Operation
- Body Control Module (BCM). Removal and Installation
- SYNC Module [APIM]. Removal and Installation
Diagnostic Methods. Description and Operation
This document provides critical diagnostic knowledge required for successful repair outcomes. It identifies technical competencies expected by users of this manual.
Ford Diagnostic Assumptions
Ford diagnostics assume the vehicle concern described by the test title is currently present. Exceptions to this rule are noted in each test. Do not replace modules or other components as directed by a diagnostic if the concern is not present at the time of testing.
