Lincoln Navigator: Steering Column / Steering Wheel. Removal and Installation
Removal
NOTE: Removal steps in this procedure may contain installation details.
NOTE: High series heated steering wheel shown, all others similar.
NOTE: Make sure the wheels are in the straight ahead position.
-
Remove the driver airbag.
Refer to: Driver Airbag (501-20B Supplemental Restraint System, Removal and Installation).
-
Disconnect the steering wheel electrical connector(s).
 |
-
NOTE: Make sure the tick-mark on the end of the steering column shaft is on the top position.
Remove and discard the steering wheel retainer and remove the steering wheel.
Torque: 46 lb.ft (62.5 Nm)
 |
-
Tape the clockspring rotor to the outer housing to keep it from rotating.
 |
Installation
-
To install, reverse the removal procedure.
Steering Column Upper Shaft. Removal and Installation
Removal
NOTE:
Removal steps in this procedure may contain installation details.
NOTE:
Do not allow the steering column to rotate while the
steering column shaft is disconnected or damage to the steering column
internal sensor may result...
Other information:
Lincoln Navigator 2018-2026 Workshop Manual: Transmission. Overhaul
Special Tool(s) / General Equipment 100-001 (T50T-100-A) Slide Hammer 100-002 (TOOL-4201-C) Holding Fixture with Dial Indicator Gauge 205-1018Installation Tube 307-003 (T57L-500-B) Holding Fixture, Transmission 307-091Handle, Torque ConverterTKIT-2009TC-F 307-309Remover, Torque Converter SealTKIT-1994-FMH/FLMHTKIT-1994-..
Lincoln Navigator 2018-2026 Workshop Manual: Gateway Module A (GWM). Removal and Installation
Removal NOTE: Removal steps in this procedure may contain installation details. NOTE: If installing a new module, it is necessary to upload the module configuration information to the scan tool prior to removing the module. This information must be downloaded into the new module after installation. Using a diagnostic scan tool, begin the PMI process for the GWM fol..
Categories
- Manuals Home
- 4th Gen Lincoln Navigator Service Manual (2018 - 2026)
- Transmission Fluid Level Check. General Procedures
- Liftgate Trim Panel. Removal and Installation
- Head Up Display (HUD) Module Calibration. General Procedures
- Rear Bumper. Removal and Installation
- All Terrain Control Module (ATCM). Removal and Installation
Front Stabilizer Bar Link. Removal and Installation
Removal
NOTICE: Suspension fasteners are critical parts that affect the performance of vital components and systems. Failure of these fasteners may result in major service expense. Use the same or equivalent parts if replacement is necessary. Do not use a replacement part of lesser quality or substitute design. Tighten fasteners as specified.
NOTE: Removal steps in this procedure may contain installation details.
With the vehicle in NEUTRAL, position it on a hoist.Refer to: Jacking and Lifting (100-02 Jacking and Lifting, Description and Operation).
NOTICE: Do not use power tools to remove or install the stabilizer bar
